Tips
Quick Troubleshooting
Section titled “Quick Troubleshooting”| Problem | Quick Fix |
|---|---|
| Touchscreen taps in wrong spot | Settings > System > Touch & Input (shown only when recalibration is needed) |
| Panel shows “Disconnected” | Check Moonraker is running, network is up |
| Temperature not changing | Verify heater is enabled in Klipper config |
| Can’t extrude | Heat nozzle above minimum temp first |
| AMS not showing | Check Happy Hare/AFC is configured in Klipper |
For detailed troubleshooting, see TROUBLESHOOTING.md.
When to Use Which Panel
Section titled “When to Use Which Panel”| I want to… | Go to… |
|---|---|
| Start a print | Home panel, tap print area |
| Change nozzle temp | Home panel, tap nozzle temp (or Controls) |
| Move print head | Controls, Motion |
| Load filament | Controls, Extrusion (single) or Filament (AMS) |
| Level my bed | Advanced, Bed Leveling |
| Run a custom macro | Advanced, Macros |
| Check print history | Advanced, Print History |
| Change theme | Settings > Display & Sound > Theme Colors |
| Fix touch calibration | Settings > System > Touch & Input (shown for any touchscreen) |
Further Reading
Section titled “Further Reading”- Troubleshooting — Solutions to common problems
- Configuration — Detailed configuration options
- FAQ — Frequently asked questions
- Installation — Installation instructions
Prev: Beta Features | Back to User Guide